FAQ
- At the moment: rods min. 70µm hot dip galvanized, plates 20 µm pre-galvanized
- A short instruction with specifications on how to perform a soil test is available
- Up to 11% no snow, ~5% with snow up to 30 psf, 3.5% for snow above 30 psf
- (Hydraulic) Drill hammer (combined impact drill could be used with rocky ground)
- Pressing tool for pressing the plates, pictures available
- Recommended tool list is described in installation manual
- Framed modules, approved for corner clamping
- Please double-check installation manual of module for further information
- In general we prefer modules with an inner frame width of 28, 30 or 35 mm (1.1, 1.2 or 1.4 inch), compatible to standard PEG plates
- List of approved modules is available for sharing
- The middle clamp is a piercing clamp of Jurchen Technology. It has small piercing points ensuring the earthing of the module via the plate to the ground.
- In general PEG should be built in blocks without any/or almost none terracing. Standard block size is 31m (34 yd) N-S and 35m (37 yd) O-W (31×40 m, 34×44 yd possible after examination)
- Thermal extension shall not exceed 50 mm (1.97 inch)
- At the moment: rods min. 70µm hot dip galvanized, plates 20 µm pre-galvanized
- A short instruction with specifications on how to perform a soil test is available
- Up to 11% no snow, ~5% with snow up to 30 psf, 3.5% for snow above 30 psf
- (Hydraulic) Drill hammer (combined impact drill could be used with rocky ground)
- Pressing tool for pressing the plates, pictures available
- Recommended tool list is described in installation manual
- Framed modules, approved for corner clamping
- Please double-check installation manual of module for further information
- In general we prefer modules with an inner frame width of 28, 30 or 35 mm (1.1, 1.2 or 1.4 inch), compatible to standard PEG plates
- List of approved modules is available for sharing
- The middle clamp is a piercing clamp of Jurchen Technology. It has small piercing points ensuring the earthing of the module via the plate to the ground.
- In general PEG should be built in blocks without any/or almost none terracing. Standard block size is 31m (34 yd) N-S and 35m (37 yd) O-W (31×40 m, 34×44 yd possible after examination)
- Thermal extension shall not exceed 50 mm (1.97 inch)