FAQ

  • At the moment: rods min. 70µm hot dip galvanized, plates 20 µm pre-galvanized
  • A short instruction with specifications on how to perform a soil test is available
  • Up to 11% no snow, ~5% with snow up to 30 psf, 3.5% for snow above 30 psf
  • (Hydraulic) Drill hammer (combined impact drill could be used with rocky ground)
  • Pressing tool for pressing the plates, pictures available
  • Recommended tool list is described in installation manual
  • Framed modules, approved for corner clamping
  • Please double-check installation manual of module for further information
  • In general we prefer modules with an inner frame width of 28, 30 or 35 mm (1.1, 1.2 or 1.4 inch), compatible to standard PEG plates
  • List of approved modules is available for sharing
  • The middle clamp is a piercing clamp of Jurchen Technology. It has small piercing points ensuring the earthing of the module via the plate to the ground.
  • In general PEG should be built in blocks without any/or almost none terracing. Standard block size is 31m (34 yd) N-S and 35m (37 yd) O-W (31×40 m, 34×44 yd possible after examination)
  • Thermal extension shall not exceed 50 mm (1.97 inch)